Urethane bushing kit for the ND Miata made by Odula. This bushing kit replaces the stock rubber bushings in the rear knuckle to cancel out minor toe alterations during bumps and shudders to the suspension system. Learn More

4 point roll cage by Saito of Japan for the ND (2016+) MX-5 Miata (Soft Top). This roll cage will not only provide a healthy amount of rigidity to the ND body, it will also make your Miata safer in the event of a roll. The standard kit is a 4 point setup, with optional add on bars available. The kit is also available in three different materials to fit a variety of budgets. The roll bar comes unassembled without pads.

Disclaimer : Please be advised that this item has correct pricing for shipping within the lower 48 states of the United States & Canada (BC, AB, SK, MB, ON, QC & NB)

If an order is submitted with a shipping address outside of the above locations, we will need to confirm the shipping cost on a case-by-case basis. We recognize the inconvenience this may pose and appreciate your understanding, as the size of the box for this product is extremely big, it is impossible to provide live international shipping rates.

For customers residing outside the above locations who are interested in this product, we suggest that you send us an email including your full address so we can estimate the total cost to your destination.

Compliance Notice : Important Safety & Compliance Notice

This roll bar uses bolt-on mounting points and is approved for road and track use in Japan. However, motorsport and track regulations vary by country and sanctioning body, and this product may not meet requirements outside of Japan.

For customers outside Japan, this roll bar should be considered primarily for cosmetic and chassis rigidity purposes only, unless compliance is confirmed with the relevant track or organization prior to purchase.

Due to the nature of this product, all sales are final. Returns, exchanges, or refunds are not accepted.

By purchasing, you acknowledge and accept these terms.

Learn More

Rear Rigid Collars manufacturer and patented by Spoon for the ND Mazda MX-5 (2016+). It is a full set (front and rear) made of 24 pieces. These pieces install between the body and subframe to reduce the little gap that will cause low-level vibrations and reduce overall rigidity of the car. The Rigid Collars will : -Reduce pull-up/oscillation during engine start up -Vibration is reduced during idling -Straight line stability is improved -Steering adjustment is reduced -Rolls smoother & reduce fatigue during driving In other words, it'll improve the ride greatly. Please note that photo is not the actual product, but a rendition of it. Learn More