Side deflector made by Jet’s in JAPAN. Covers a part where usually tires stick out because of low offset wheels. It will also make the car more aerodynamic. Learn More

Rear deflector made by Jet’s in JAPAN. Adds some aggressive touch to the rear end of the vehicle. It will also make the car more aerodynamic. Learn More

Front Spoiler (Air Dam) made by Jet’s (Integral Kobe) for 2013-2015 years NC3 MX-5 that is made with their special 3D wing shape. The 3D wing shape is made to be 100% functional and was tested on track to be sure it works. It’s made to both enhance down force and improve cooling to the engine bay. Learn More

Front Lip made by Jet’s (Integral Kobe) for 2009-2012 NC MX-5s that is made with their special 3D wing shape. The 3D wing shape is made to be 100% functional and was tested on track to be sure it works. It’s made to both enhance down force and improve cooling to the engine bay. Learn More

Front Lip made by Jet’s (Integral Kobe) for 2006-2008 NC MX-5s that is made with their special 3D wing shape. That specific shape is made to be 100% functional and was tested on track to be sure it works. It’s made to both enhance down force and improve cooling to the engine bay. Learn More

Front Lip made by Jet's Integral Kobe for the 2016+ ND Miata. It's made to flow perfectly with the OEM canards, but also made to improve downforce. It also contributes to help high speed stability of the vehicle. Learn More

Set of fenders made by Jet’s to fit NC chassis MX-5. It’s designed with downforce in mind and to add cooling efficiency to the engine bay. It also follows the lines of the NC quite well. It is possible to re-use OEM tube liners (fender guards) inside of these fenders (some cutting into them is needed due to the duct). In order improve engine cooling more efficiently, cutting to the fender guards need to be done (can be done with scissors). Learn More

Product made by Jet's (Integral Kobe) for the MX-5 NC-1 and NC-2 (06-12). The master spec canards are made to flow well with the lines of the vehicle and add downforce (track tested). It'll work most efficiently at high speed and while cornering. Learn More

Springs made to fit onto OEM ND (2016+) Suspension to offer a more sporty handling, keep vehicle's balance and lower the ride height. It lowers the vehicle about 30mm in the front and 25mm in the rear. You can read our blog post about track results from these springs!

Learn More